Dishes are not
dried.
Rinse aid dispenser is
empty.
Make sure there is sufficient rinse aid
in the dispenser.
Also see the drying hints in “At the end
of the wash program” on page 25.
Dishes are not
clean.
Wrong program selection Select a more intensive wash program.
Improper basket loading Make sure the action of the detergent
dispenser and spray arms are not
blocked by large tableware.
Spots and
filming on
glasses and
dishes
• Extremely hard water
• Low water temperature
• Overloaded
dishwasher
• Inappropriate loading
• Old or damp powder
detergent
• Empty rinse aid
dispenser
• Incorrect detergent
dosage
• To prevent this from occurring,
make sure to prepare and load
the dishwasher according to the
instructions (see pages 16-23) and
select the appropriate wash program
(see pages 14-15).
• To remove spots from glassware,
wash it in the dishwasher on the
longest cycle without any detergent
and without any metal utensils. After
about 18-22 minutes, when the
main wash has started, open the
door carefully and pour two cups
of white vinegar into the bottom
of the dishwasher. Close the door,
press START/PAUSE and let the
dishwasher complete the cycle. If
the vinegar remedy does not work,
repeat as above, except use 1/4 cup
(60ml) of citric acid crystals instead
of vinegar.
Cloudiness on
glassware
Combination of soft
water and too much
detergent
Use less detergent if you have soft
water and select the shortest wash
program to wash your glassware.
White film
on the inside
surface of the
dishwasher
Hard water minerals To clean the interior, use a damp
sponge with a little dissolved dish-
washer detergent; make sure to wear
rubber gloves. Never use any other
cleaner than dishwasher detergent to
avoid the risk of foaming or suds.
Problem Possible cause Solution
FAQs (Cont.)
To Next Page
Loading...
