STMicroelectronics STM32 Series - IBM Cloud Configuration Steps; Serial Interface Configuration Parameters; Wi-Fi Credential Input for B-L475 E-IOT01 A

FP-CLD-WATSON1
Configure IBM Cloud Configuration Parameters
via serial interface(1/2)
15
1. Configure a serial terminal with the following parameters to view log messages and write AP
parameters. Tested with Teraterm version 4.96
• BaudRate : 115200
• Data : 8 bit
• Parity : none
• Stop : 1 bit
2. B-L475E-IOT01A requires Wi-Fi connectivity, provide Wi-Fi Credentials using terminal. This
step is not needed for Nucleo-F429ZI based configuration:
• Flow Control : none
• NewLine RX AUTO
• NewLine TX : CR+LF
• Local echo: Enabled