SUPPORT@STOREITCOLD.COM
2020 © Store It Cold, LLC. 12 Rev 2020-8A. All Rights Reserved.
GENERAL TIPS FOR PROPER DOOR INSTALLATION
• Level and plumb door frame
• Frame legs are level to each other.
• Frame legs are to be in plane with each other. Check with 4’ straight edge across door
face at bottom of doorway.
• Frame legs are parallel and not spread out. Opening width at bottom of doorway to
match width at top of doorway.
• On coolers with a floor, ensure the door panel cam-locks are locking correctly with
the floor ones when engaged
• Verify function of door, door locks and emergency release when door is locked.
• Adjust door closer if needed.
8. Proceed to install the rest of the wall panels in the same way the other wall panels where
installed, leaving the front left or right corner for last.
To Next Page
Loading...
