SUPPORT@STOREITCOLD.COM
2020 © Store It Cold, LLC. 31 Rev 2020-8A. All Rights Reserved.
ELECTRICAL INSTALLATION
IMPORTANT!!
Electrical installation for your cooler SHOULD be performed by a qualified electrician to ensure
correct power supply, wiring, and compliance with local codes.
IMPORTANT!!
The enclosure does not have any predrilled holes or electrical outlets from the factory.
Drilling holes on the panels to run conduit to bring power inside the cooler is OK and will not void
the warranty of your panels - as long as the installation is done by a qualified electrician.
All OUTLET BOXES and JUNCTION BOXES installed should be surface mount.
On outdoor coolers, electrical installations should be done ONLY AFTER your outdoor membrane has
been installed. Make absolutely no roof penetrations for electricity or other services. All penetrations
on outdoor coolers must go through the side walls on outdoor coolers.
To Next Page
Loading...
