What to do if my Stormchaser Scrubber has no power?
If your Stormchaser Scrubber is experiencing a loss of power, there are a couple of things you can check. First, examine the building's circuit breaker or fuse box to see if there's a dead electrical circuit. Also, a faulty power cord could be the culprit, in which case you should replace it.
Why is my Stormchaser Scrubber losing vacuum?
A loss of vacuum in your Stormchaser Scrubber can occur due to several reasons. Here's what you can check: * Ensure the vacuum dome is centered and sealed over the tank. * Inspect the dome for cracks or poor joints; replace or repair it using acrylic plastic cement. * Clean the vacuum screen if it's clogged with lint or dirt (do this with the power off). * Tighten the cuffs on the vacuum hose by turning them counterclockwise. * Replace vac motor seals if they are leaking. * Wash out the floor tool vac chamber with a hose to remove any clogs, and use a wire to pick out lint. * Replace the vac motor, hose, or dome gasket if necessary.
What to do if Stormchaser Scrubber pump will not run?
If the pump on your Stormchaser Scrubber isn't running, first ensure the unit is properly connected to a 3-prong grounded outlet. If it is plugged in, the issue might be loose wiring; in this case, you should see a dealer.
What to do if I get an electrical shock from my Stormchaser 900-01 Scrubber?
If you're experiencing electrical shock from your Stormchaser Scrubber, ensure that the equipment is properly grounded by following the grounding instructions exactly. If the receptacle isn't grounded, contact an electrician to inspect the building’s wiring. An internal wiring problem could also be the cause, so have a trained service technician check the machine’s wiring.
What to do if the Stormchaser 900-01 Scrubber pump runs but there is a loss of pressure?
If the pump on your Stormchaser Scrubber runs but you're experiencing a loss of pressure, it could be due to internal pump components wearing out, in which case you should replace them. Also, check the valves in the pump head for particles or cuts in seals, take the piston from BPR and lubricate it with Superlube; if the problem persists, change the BPR kit.
Why does the vac motor speed vary or not run on my Stormchaser Scrubber?
If the vacuum motor speed varies or doesn’t run on your Stormchaser Scrubber, it could be due to worn motor brushes, in which case you should replace them. Alternatively, the motor itself might be worn out and need replacement, or there could be a faulty switch that also requires replacement.
What to do if the Stormchaser 900-01 pump runs but there is no solution?
If the pump runs on your Stormchaser Scrubber but no solution is coming out, check if the pump inlet screen is plugged and clean it. The pump may be air locked, so press the trigger to open the valve on the cleaning wand to relieve air. Also, inspect the internal or external solution line for damage and leaks, and replace if necessary.
How to connect solution hose fitting on Stormchaser 900-01 if it's hard?
If the solution hose fitting on your Stormchaser Scrubber is hard to connect, it might be due to corrosion on the fittings. Clean them with steel wool, soak them in acetic acid (white vinegar), and lightly lubricate them with a silicone-based lubricant.
Describes the Stormchaser as a commercial carpet extractor.
Details on product registration and customer assistance.
Essential safety guidelines for operating the appliance.
Guides users through diagnosing and fixing common machine problems.
General| Brand | Stormchaser |
|---|---|
| Model | 900-01 |
| Category | Scrubber |
| Language | English |
To Next Page