18
4. Adjusting the treadmill deviation
While using the belt, the running surface may start to tilt sideways. In this case, it is
necessary to re-center the treadmill according to the following steps:
a) Place the belt on a horizontal surface and set the speed to approx. 5-6 km/h.
b) If the treadmill deflects to the right, turn the right screw at the end of the
treadmill half a turn clockwise and the left screw half a turn counterclockwise.
c) If the treadmill deflects to the left, turn the left screw at the end of the treadmill
half a turn clockwise and the right screw half a turn counterclockwise.
d) If the belt still deflects sideways, repeat one of the previous steps.
5. Lubricating the treadmill
The underside of the treadmill/surface or the tread plate under the treadmill requires
regular maintenance in the form of lubrication with silicone oil. Maintaining the correct
tension between the belt and the plate has a great influence on the life of the treadmill.
Proceed as follows:
a) Turn off the main belt switch and slightly loosen the treadmill/treadmill surface.
b) Wipe off dust and dirt between the belt and the plate with a clean cloth.
c) Evenly apply a small amount of silicone oil from above between the belt and
the plate at the front of the belt.
d) Re-tension the treadmill and set it in motion to spread the oil over the entire
running surface.
We recommend applying the included lubricant after approximately the first 40 hours of
operation. We also recommend lubricating the platform according to the following
schedule:
To Next Page
Loading...