Witheachwashcycle.
Compartment
For programmes with pre-wash on ly.
(Follow the user instr uctions!)
Electric indic ator on control panel (if provided).
Check the rinse aid level
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programme
Close the door, turn on the water tap. The mac hine will start working after about 1 0 seconds.
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the deter gent disp enser
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handl ing
the dishes and utensils while they are still hot and more susceptible to break.
The y will a lso dry better.Unload the appliance, starting fro m the lower b asket.
Changing the programme
Add forgotten dishes in the
dishwasher .
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then l oad the baskets. Refer to the dishwasher loading instructions.
Press the Programm e button until the selected programme lights up .
( See the section entitled Operation instruction )āā
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the ON/OFF button.
If the appliance is switched
off during a wash cycle.
Open t he do or c aref ul l y.
Hot st eam may escape
when the door is opened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance Press the On/Off bu tton to switch on the appliance, Open the door.
1.Open the door a little to stop the dishwasher.
2.After the spray arms stop work ing, you c an open the door completely.
3.Add the forgotten dishes.
4.Close the door, the dishwasher w ill start running again after 10 sec onds.
For detailed operating method read the corresponding content on t he instruction manual.
1. A running cycle can only be modified if it has been run ning for a short time. O therwise the detergent
m ay have already been rele ased and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Open the do or a lit tle to s top the washing, then press the Program button for more than 3 seconds to
c ancel the running programme.
3. Selec t a new programme, then close the door. The machine will restart after about 10 seconds.
To Next Page
Loading...