Strasbaugh Operator Functions
Version 4.0 - February 1998 3 - 11
CALIBRATION/CONFIGURATION CHANGES
Reflecting a reorganization of the handling of calibration and configuration
choices, the Calibration/Configuration Menu of Version 4.25 and later
contains only technician level calibration variables and one-time machine
configuration that would not be changed by an operator or engineer.
The Calibration Menu of previous software versions contained some choices
that could affect process and operation. These choices have been moved to
either the Conditioning Parameters Menu or the Machine Parameters Menu
as appropriate.
For Further Information:
Refer to Operations: Chapter 4 - Machine Setup; Maintenance: Appendix A
- Calibration Variables.
Operations: Chapter 4 - Machine Setup contains a table (repeated in
Maintenance: Appendix A - Calibration Variables) comparing "before and
after" use of the Calibration Menu and listing the menus at which relocated
choices may be found.
To Next Page
Loading...
