STRASBAUGH, INC.
August 11, 1995 6DS-SP Ver 4.15 Page 12
7) Set the following calibration/configuration variables as required.
Variable 137, "Dual Slry Source (0-no, 1-yes)"
Set to "1" only if the option is installed. Otherwise set to "0"
Variable 159, "Slurry diverter (0-no, 1-yes)"
Set to "1" only if the option is installed. Otherwise set to "0"
Variable 98, "Light tower config. (0, 1)"
Set to "0" if a three light tower (or no light tower) is installed.
Set to "1" if a four light tower is installed.
Variable 74, "Cond force amp offset (lbs)"
Should be "0" when software with this variable is first installed.
If not, set to "0".
NOTE: When done saving or installing software, remove the floppy disk from the
computer disk drive. Always keep floppy disks in a cool dry place.
To Next Page
Loading...
