Strasbaugh Operator Functions
Version 4.0 - February 1998 3 - 69
OPERATION OF A TABLE CONDITIONING CYCLE
USING THE CONDITIONING ARM
Follow the procedure below to condition the table by running a pad
conditioning cycle at the Auto Polish Menu.
SUMMARY
1. Power Up.
2. Perform Home Sequence Routine.
3. Retrieve a Stored Recipe.
4. Run Auto Polish Cycle Using the “Pad Conditioning” Feature.
Assumptions - The procedures below were written with the assumptions that:
• The operator has read the Basic Operation section of this chapter
(above).
• The operator has installed the polishing pad. (See the Operator Routine
Maintenance section, below, for procedures).
To Next Page
Loading...
