Operations Model 6DS-SP Planarizer
3 - 86 Version 4.0 - February 1998
2. With the flat side of the white plastic carrier load fixture
facing up, place the fixture between the load station and
the front of the machine.
3. Confirm that the lip of the fixture engages with the front
wall of the machine cabinet.
4. Confirm that the fixture is positioned directly in front of
the desired load station.
5. Place the carrier on the fixture.
6. Slide the carrier toward and under the spindle until it
drops into the load station.
CAUTION: Take care to avoid damaging the teflon spray
nozzles located near the load stations.
7. To load a second carrier, repeat Steps 4., 5., and 6.,
immediately above.
8. Remove the fixture.
Note: To avoid damage to the machine, always
remove the fixture before beginning any
other procedure.
9. Close all doors to the machine.
Select the Auto Polish Cycle Menu:
Operator Action Explanation/Screen Display
10. <F9> Press the F9 key to choose
“Select Menu”.
11. <F1> Display the Auto Polish Cycle
Menu by pressing the F1 key to
select “Auto Cycle”.
To Next Page
Loading...
