Strasbaugh Machine Setup
Version 4.0 - February 1998 4 - 21
FUNCTION KEY CHOICES AVAILABLE AT THE SWEEP
PARAMETERS MENU
Key Label Function(s)
Move
Up
"Move Up" moves the cursor up one item in the present
column. If already at the top will "wrap" to the bottom of that
column.
Move
Down
"Move Down" moves the cursor down one item in the present
column. If already at the bottom will "wrap" to the top of that
column.
Move
Left
"Move Left" moves the cursor one column to the left.
Move
Right
"Move Right" moves the cursor one column to the right.
Times
= 1st
"Times = l st" sets all steps to the time showing in the first
step. (This is useful if all times are to be the same.)
Forces
= 1st
"Forces = lst" sets all forces to the force showing in the first
step. (This is useful if all forces are to be the same.)
Set
Outer
"Set Outer" permits setting the outer position of the sweep
range as measured from the table center. The value is entered
on the prompt line.
Set
Inner
"Set Inner" permits setting the inner position of the sweep
range as measured from the table center. The value is entered
on the prompt line.
To Next Page
Loading...
