Strasbaugh Machine Setup
Version 4.0 - February 1998 4 - 29
Menu Item Descriptions at the Conditioning/Cleaning Parameters Menu
(Screen Page 2)
Item Function(s)
Sweep Stroke Style
(ignored when in-situ
conditioning)
One Way
Two Way
Single
The conditioning arm will sweep across the table
and then lift for the return stroke for each
conditioning cycle.
The conditioning arm will sweep across the table in
both directions for each conditioning cycle.
(Programmable arms only) The conditioning arm
will sweep across the table once for each
conditioning cycle.
Sweep Stroke Start
(ignored when
in-situ conditioning)
Outer
Inner
The conditioning arm will start at the outer
position.
The conditioning arm will start at the inner
position.
In-situ Conditioning
Enbl/Dsbl
Conditioning will occur during polishing. ("Outer"
will be used for sweep start and "Two Way" for
sweep style regardless of how they are set.)
In-situ Duty Cycle
If using in-situ conditioning, sets the percentage of
time conditioning occurs during polishing. The
arm is raised
and conditioning is paused the required time after
each complete 2 way sweep to effect the duty cycle.
If the duty cycle is set to 100%, in-situ conditioning
will be
continuous. If set to 0%, there will be one 2 way
sweep after which the arm will raise and pause
indefinitely.
Carrier Cleaning Interval
(Single table machines only) Sets how many
polish cycles can occur before a carrier clean
cycle.
To Next Page
Loading...
