Strasbaugh 6DS-SP - Page 293

Strasbaugh Troubleshooting
Version 4.0 - February 1998 5 - 35
“LEFT SPINDLE SPEED LOW ALARM” - # 3
“LEFT SPINDLE SPEED HIGH ALARM” - # 4
“RIGHT SPINDLE SPEED LOW ALARM” - # 7
“RIGHT SPINDLE SPEED HIGH ALARM” - # 8
PART B
Problem
Indicator
Problem
Location
Component/ Cause
Resolution
(3) Screen message
indicates table and
spindle speeds are
too slow.
(4) After completing
Resolution 3a and
3b, table and
spindle still not
moving or moving
at wrong speed.
(3a) Check alarm
parameters on Alarm
Parameters menu to
see if the alarm
parameters are within
range of the Auto
Polish Cycle
Parameter settings.
(3b) If speed is
correctly entered for
both table and spindle,
and they are still not
turning, power the
machine down.
Wait 30 seconds.
Power up again.
Test.
OPERATIONS/
MAINTENANCE
(4a) Call
manufacturer for
assistance.
STRASBAUGH