Strasbaugh 6DS-SP - Page 292

Operations Model 6DS-SP Planarizer
5 - 34 Version 4.0 - February 1998
“LEFT SPINDLE SPEED LOW ALARM” - # 3
“LEFT SPINDLE SPEED HIGH ALARM” - # 4
“RIGHT SPINDLE SPEED LOW ALARM” - # 7
“RIGHT SPINDLE SPEED HIGH ALARM” - # 8
PART A
Problem
Indicator
Problem
Location
Component/ Cause Resolution/
Responsibility
ALARM
SOUNDS
DURING AUTO
POLISH
CYCLE
Control Panel.
The bottom of the
monitor screen
will display a
message showing
the cause.
(1) Machine
parameter out of
range of a
programmed alarm
parameter.
(2) Screen message
indicates table and
spindle speeds are
too fast (results in
poor polish
product)
Note: The alarm is a
warning device--it does
not abort the cycle.
(1a) Read the bottom
of the screen for
message.
(1b) Press the CYCLE
HALT button.
(2a) Check alarm
parameters on Alarm
Parameters menu to
see if the alarm
parameters are within
range of the Auto
Polish Cycle
Parameter settings.
OPERATIONS