Strasbaugh Software Calibration Procedures
Version 4.0 - February 1998 10 - 15
MANUAL CONTROL MENU (SCREEN PAGE 2)
This menu/page allows manual manipulation of the conditioning arm, spindles,
and tables.
If the programmable conditioning arm is installed, the Cond Arm Move choices
will be Park, Outer, and Inner. The outer and inner positions will be whatever is
currently showing on the Sweep Parameters menu.
If the non-programmable conditioning arm is installed, the Cond Arm Move
choices will be Left, Right, and Off. Since the non-programmable arm has no
means to automatically stop, select Off before it reaches the end of its travel.
To Next Page
Loading...
