Strasbaugh Software Calibration Procedures
Version 4.0 - February 1998 10 - 57
ELEVATORS AND ROBOT--
ORDER OF ADJUSTMENT
When adjusting the elevators and robot, be sure to follow the order shown below
for performing the mechanical adjustments and software calibration procedures.
Note: As procedures are grouped in this chapter by component for ease of
location, you will need to move from the Robot section to the Elevator
section and back to the Robot section to complete the procedures in the
order required.
THROUGHPUT OPTION - If the front-to-back or side-to-side throughput
option is installed in your machine, refer to the Throughput Option Addendum to
the 6DS-SP Maintenance manual for the software selections and maintenance
adjustments required for operation.
To Next Page
Loading...
