Strasbaugh Machine Description
Version 4.0 - February 1998 2 - 19
CONTROL COMPUTER
The section below introduces the control computer and provides an
illustration of each of the sixteen 6DS-SP 4.25 software menus.
WHERE TO FIND MORE INFORMATION
ON THE SOFTWARE...
For a detailed introduction to the 4.25 software, refer to the Operator
Functions chapter of the 6DS-SP Operations manual.
Note: For post-4.25 software versions, feature descriptions and
information contained in the 6DS-SP User Interface Reference
documentation take precedence over information in this manual.
To find information on a specific menu, see the Menu Information Locator
table in the Contents section at the front of each manual volume.
For information on 4.25 and post-4.25 software version features, refer to the
6DS-SP User Interface Reference documentation, located in Appendix A
of the 6DS-SP Maintenance manual.
Note: With each new 6DS-SP software release, replace the 6DS-SP
Calibration/Configuration Reference and 6DS-SP User
Interface Reference documentation found in Appendix A of the
6DS-SP Maintenance manual with the new documentation
received in the software release.
WHERE TO FIND MORE INFORMATION
ON THE CONTROL COMPUTER
SYSTEM...
The system unit of the control computer is detailed in the Control System
Description chapter of the 6DS-SP Maintenance manual.
To Next Page
Loading...
