Strend Pro E40 - Intended Use; Inside the Package

ENGLISH
INTENDED USE
Handheld laser distance meter is intended for measuring distances, lengths, heights, clearances, inclines,
calculating areas and volumes.
Use the device only for prescribed purposes. Any other use is considered as an instance of misuse. The user
/ operator and not the manufacturer will be responsible for any damage or injury caused by such misuse.
Remember that this device has not been designed for commercial or industrial use. The warranty will not
apply if the device is used for commercial, industrial or similar purposes.
TECHNICAL PARAMETERS
MODEL
E40
E80
MEASURING RANGE
0.05m ~ 40m
0.05m ~ 80m
RESOLUTION
1 mms
ACCURACY
± 1,5 mm
MEASURING SPEED
approx. 0,5 s
MEMORY CAPACITY
99
LASER TYPE
620 – 690 nm, Class II, < 1 mW
BATTERY
2 x 1,5 V AAA batteries
BATTERY LIFE
> 8 000 measurements
OPERATION TEMPERATURE
0°C to 40°C
STORAGE TEMPERATURE
-20°C to + 65°C
DEVICE POWER OFF
after 180 s
LASER POWER OFF
after 20 s
WEIGHT
approx. 82 g
DIMENSIONS
115 (length) x 50 (wide) x 23 (height) mm
* The deviation occurs under unfavorable conditions such as bright sunlight or when measuring too poorly
reflecting or very rough surfaces, the environment temperature is too high or too low.
** When measuring distance within 10m, measurement accuracy is ±1.5mm; more than 10m,
measurement accuracy is calculated as follows: ±1.5mm ± 0.05* (measuring distance -10).
FEATURES
- continuous measurement
- max. / min. measurement
- area / volume / Pythagoras
- plus and minus
- „m” (meter) /„ft” (foot) /„in” (inch) switch
- measuring reference
- buzzer indicator
- data clean up
error message code
- battery indicator
- digital level (angle measuring)
- telemeasuring height directly, even though there are some barriers in front of target.
INSIDE THE PACKAGE
- handheld laser distance meter
- 2 x 1,5 V AAA batteries
EN