MAINTENANCE
Read the maintenance schedule and observe these recommendations to extend the life of your ice auger.
Good maintenance is essential for safe, economical, and trouble-free operation. To help you properly care for
your Powerhead, the following pages include a maintenance schedule, routine inspection procedures, and
simple maintenance procedures using basic hand tools. Other service tasks that are more difficult, or require
special tools, are best handled by professionals and are normally performed by a technician or other qualified
mechanic.
The maintenance schedule applies to normal operating conditions. If you operate your Powerhead under
unusual conditions, such as sustained high-load, or use in unusually wet conditions, consult StrikeMaster
®
customer service for recommendations applicable to your individual needs and use.
MAINTENANCE AND SCHEDULE
MAINTENANCE ITEM BEFORE EACH DAYS USE EVERY 400-500 COMPLETE
CHARGES/CYCLES
CHECK BOLTS AND NUTS X —
BATTERY
CHARGE X —
PACK
REPLACE — X
CYCLE
One complete use from full charge to no charge. (If used to 75% charge, it counts as 25% of cycle.
TRANSPORTING YOUR ICE AUGER
Remove the Battery when transporting the auger.
LONG-TERM STORAGE
If your ice auger will not be run for more than one month, prepare it for long-term storage.
1. Charge the battery to full and leave it off of the ice auger. DO NOT leave the Battery on the Battery Charging
Base.
2. Remove the auger from the Powerhead and apply a thin layer of grease to the driveshaft.
3. Remove all debris from Auger and Powerhead.
4. Keep in a dry, moisture-free area.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE REMEDY/ACTION
Powerhead will not turn on Power Switch not Hold Power Switch for five seconds
depressed properly
Powerhead will not start and Battery too cold Remove Battery from the unit and place
the Battery indicates a in a warm location (inside a jacket pocket,
full charge vehicle or a small cooler with a warmer)
Powerhead starts then stops Battery low on power Charge Battery
Battery may be slightly Remove Battery from the unit and place
under temperature in a warm location (inside a jacket pocket,
vehicle or a small cooler with warmer.
In the event of the auger not operating or stalling during use the user may hear audible signals. To determine
what the audible signal is keep the operating lock lever (deadman’s switch) and POWER button engaged and
count number of beeps, then refer to the chart below.
STATEMENT BEEP TIME SOLUTION
Protection Over Current 1 Release trigger, lift and continue cutting
(spiral stoppage during cut) or move and cut in new location
Protection Voltage Battery Low 7 Recharge Battery
Place Battery in warm location
Protection High Temperature 13 Release trigger,
Let unit rest for five minutes
Battery Is Too Cold 6 Warm Battery to above -4°F, or try
running unit without any load until
Battery warms
To Next Page
Loading...
