To Next PageTo Next Page
Need help?Do you have a question about the Stromberg Carlson Products BC-204 and is the answer not in the manual?
General| Brand | Stromberg Carlson Products |
|---|---|
| Model | BC-204 |
| Category | Automobile Accessories |
| Language | English |
Connect the Short Support Base Assembly with Horizontal Arms using provided hardware.
Insert Vertical Arm into the Short Support Base Assembly and secure with bolts.
Attach the Folding Shank to the Short Support Base Assembly using the M16 bolt.
Assemble the extension frame by connecting the Long Support Base Assembly.
Repeat assembly step for the Vertical Arm on the Long Support Base.
Insert the Long Support Base into the Short Support Base and secure.
Slide Left and Right Cradle Assemblies onto the Horizontal Arms and tighten.
Install J-Hook Assemblies onto the Vertical Arm and secure the reflector.
Insert the Folding Shank into the 2" receiver hitch and secure with pin.
Loosen knob, rotate vertical tube down, then load the first bicycle.
Load bicycles into cradles, adjust positions, and tighten to secure.
Loop wheel cradle straps over each wheel and secure to prevent dislodging.
Load second/third/forth bicycles, reversing direction for handlebar clearance.
Allows access to vehicle rear by tilting the rack downward after pin removal.
Loosen knob to rotate support tube to vertical states for storage.
Fold Vertical Arm horizontally and Folding Shank vertically for storage.
