StrombergCarlson.com • 231.947.8600
STEP 1 STEP 2
NOTICE
The sliding
teeth face
this direction
INS-BC204-C 10.27.2022
Four Bike
Platform Mount Carrier
Model: BC-204
Assembly Instructions
Four Bike Platform Mount Carrier BC-204
Assemble the primary frame by connecting the Short
Support Base Assembly (part #1) and (2) Horizontal
Arms (part #2), using (2) 5/16” knob, (4) 5/16” flat
washer, (2) 5/16” spring washer, (2) 5/16” hexagon
bolt, (2) M10 Carriage bolts and (2) M10 Locknuts
(parts #3, #4, #5, #6, #27 and #28). (See Figure 1)
n Fits 2” receiver
n Tilts down for access to vehicle
n Wheel mounts adjust to any size frame
n Tire cradle ts up to 2-1/2” wide tire
(BC-2FT Fat Tire Adaptor available)
n Weight capacity 160 lb
Tools Needed
(1) 17mm Open Wrench
(1) 19mm Open Wrench
(1) 24mm Open Wrench
FIGURE 1 FIGURE 2
Place Vertical Arm (part #7) into the Short Support Base Assembly
by using M10 Carriage Bolt and M10 Locknut (parts #27 and #28).
With the Vertical Tube in a vertical position, insert the 5/16” hexagon
bolt (part #6), through the 5/16” flat washer (part #4), the 5/16”
spring washer (part #5) and the 5/16” flat washer (part #4), tighten
with 5/16” knob (part #3). (See Figure 2)
NOT TESTED ON OR APPROVED
FOR E-BIKES
14-1/4"
19 -1/4"
10"
10"
2-1/2"
Fits 2"x2" receiver
BC-204
1-3/8" square tubing
51-1/2" long
32"
6"
7"
To Next Page
Need help?
General
