EasyManua.ls Logo

Stromer ST2 - Warranty and Wear; Understanding Component Wear; Technical Data; Motor and Charger Specifications

Stromer ST2
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
34 35
WARRANTY, DEFECTS, WEAR
You were given the warranty and limitation of li-
ability separately at the time of purchase of your
S-pedelec. You can also consult them anytime at
www.stromerbike.com/support.
Wear
Take note that the components of the S-pedelec
are subject to higher wear than the components
of a bicycle without an additional drive. This is
due to the greater weight of the vehicle and the
higher average speed that is achieved through the
propulsion.
This higher wear is not a defect and is not subject
to warranty.
Typical components affected are:
Tires
Brake pads
The battery is subject to aging and therefore a
wearing part. Please take note that age and dura-
tion of use affect the battery, e.g. result in a clear-
ly reduced driving range. This must be considered
when planning trips. Exchange our battery in due
time for a new one. Replacement batteries are
available from your Stromer dealer.
Drive components
Spokes
TECHNICAL DATA
Permitted total weight of Stromer S-Pedelec: 140 kg
Vehicle including battery + driver + luggage + trailer
ST2 ST2 S ST1X
MOTOR
SYNO Drive* SYNO Drive* CYRO Drive*
MOTOR SUPPORT up to 45 km/h up to 45 km/h up to 45 km/h
PERFORMANCE 500 W 500 W 500 W
TORQUE 40 Nm 40 Nm 35 Nm
RANGE up to 150/180 km up to 180 km up to 150 km
* Depending on the location of use, a driving permit and insurance/number plate may be required.
CHARGERS
CR245 (ST2) CR245 (ST2S) CR190 (ST1X)
INPUT
100-240VAC
~
50-60 Hz
3A
100-240VAC
~
50-60 Hz
3A
100-240VAC
~
50-60 Hz
3A
OUTPUT
54.6VDC / 4.5A
11.2VDC / 1A
54.6VDC / 4.5A
11.2VDC / 1A
54.6VDC / 3.5A
11.2VDC / 1A
OPERATING TEMPERATURE
RANGE [°C]
0...40°C 0...40°C 0...40°C

Other manuals for Stromer ST2

Related product manuals