Struers Tegramin-30 - User Manual

Questions and Answers

J
Jessica AdamsAug 13, 2025
What to do if the surfaces are being damaged in Struers Laboratory Equipment?
- B
  Brandon OrtizAug 14, 2025
  If the surfaces are being damaged when using Struers Laboratory Equipment, it could be due to several reasons. The specimen may have burrs or sharp edges that need to be removed. Alternatively, the force applied to the specimen might be too high, or the specimen area might be too small. Try removing burrs and sharp edges, and lower the applied force to resolve this issue.
P
Perry Richardson DDSAug 17, 2025
How to fix 'process cannot be started' error in Struers Laboratory Equipment?
- D
  David SloanAug 17, 2025
  If the process cannot be started on your Struers Laboratory Equipment, and you are seeing error messages, it might be because the flexible specimen holder is too close to the surface. To fix this, try changing the force, using higher specimens, or changing the configuration.
D
David EspinozaAug 21, 2025
What to do if pins are touching the surface on Struers Laboratory Equipment?
- J
  James StewartAug 21, 2025
  If the pins on the flexible specimen holder are touching the preparation surface while using Struers Laboratory Equipment, it's likely that the force setting is too high, or the specimens are too low. You can decrease the force or increase the specimen height.
K
Katherine JonesAug 25, 2025
Why is the polishing cloth life so short on Struers Laboratory Equipment?
- P
  patrick74Aug 26, 2025
  If you are experiencing a short lifetime of the polishing cloth with your Struers Laboratory Equipment, it might be because the polishing cloth is too soft. Try using a harder polishing cloth.
R
Ronald CaldwellAug 28, 2025
What to do if specimens fall out of Struers Laboratory Equipment?
- K
  Kristin SchroederAug 28, 2025
  If the specimens fall out of the flexible specimen holder in your Struers Laboratory Equipment, it could be due to incorrect placement or insufficient force. Increase the force.
S
Sharon SullivanSep 1, 2025
Why do specimens develop a pencil shape in Struers Laboratory Equipment?
- I
  iburtonSep 2, 2025
  If the specimens develop a pencil shape when using Struers Laboratory Equipment, it could be due to several reasons: incorrect placement, a sample area that is too small, a specimen that is too high, or a specimen geometry that is round and solid. Turn the specimen and repeat the step.
K
Kimberly MillerSep 5, 2025
What causes pins to stick in Struers Laboratory Equipment?
- M
  Michael MaySep 5, 2025
  If the pins on the flexible specimen holder get stuck to the bottom plate of your Struers Laboratory Equipment, it's likely because the flexible specimen holder is dirty. Clean the flexible specimen holder.
A
Alicia GarciaSep 8, 2025
Why is it hard to insert the specimen holder in Struers Laboratory Equipment?
- B
  bbaxterSep 9, 2025
  If it is difficult to insert the flexible specimen holder in the Struers Laboratory Equipment, the coupling might be worn out. Check the coupling.