Stryker Physio Control Lifepak CR2 - Confirm Cellular Connection (If Applicable); Cellular Connection Process

6
If your AED has cellular capability,
it will attempt a cellular connection
immediately after the Wi-Fi connection
in step 5. This occurs whether or not the
Wi-Fi connection was successful. Listen
for the following voice prompts:
a. “Mobile connection initiated,”
followed by “Connection in
progress.” There will be a pause
while the AED connects.
b. “Connection established.”
Once a cellular connection is
established, the AED will update
your online account with its
Confirm the cellular connection, if applicable.
FAQs
Q: I heard “Unable to establish mobile network connection.” What should I do?
A: This may mean that the signal strength at your location is not strong enough to connect the AED to the
cellular network. If possible, move the AED installation and try again. If you need assistance, contact
Physio-Control Customer Support.
current status. The AED beeps every few seconds
during the update process.
Note: If your account was already updated during the
Wi-Fi connection, the updates are not repeated.
c. When all updates are complete, you will hear
“Communication complete,” followed by
“Powering O.”