12 www.stryker.com
EN 7205-001-700 Rev-AA
Specifications
WARNING: ALWAYS check any documentation that accompanies attachments, burs, pins, and/or blades for
special duty cycle and usage instructions.
CAUTION: ALWAYS store the equipment within the specified environmental condition values throughout its useful life.
NOTE: Specifications are approximate and may vary between devices or as a result of power supply fluctuations.
Model: System 7 Dual Trigger Rotary Handpiece (REF 7205-000-000)
Dimensions: 153 mm [6.1 inch] height
38 mm [1.5 inch] width
153 mm [6.1 inch] length
Mass: 0.99 kg [2.2 lb]
Speed: 1200 rpm (drill)
270 rpm (ream)
Forward and Reverse Modes Oscillate Mode
Mode of Operation: Non-continuous Operation Non-continuous Operation
Duty Cycle: 1 minute on/4 minutes off, 3 times 15 seconds on/15 seconds off, 5 times
Rest Between Cycles: 3 hours 1.5 hours
Maximum Temperature
of Applied Part:
Less than 51 °C [124 °F] (Maximum surface temperature as tested to the standards
listed under Product Safety Certification.)
Power Supply: Internally Powered
Refer to battery housing for voltage rating.
Ingress Protection: IPX0 Ordinary Equipment
Equipment Type:
Type BF Applied Part
To Next Page
Loading...