E-9
SNOOZE FUNCTION
When the alarm sounds, tap the SNOOZE BUTTON (#5) to temporarily turn off the
alarm and activate the snooze function, the alarm will stop and sound again 9 minutes
later. If you tap the SNOOZE BUTTON (#5) again, the alarm will temporarily turn off
again and sound again in 9 minutes and so on.
NOTES:
The corresponding AL1 or AL2 icon light and the SNOOZE icon blink on the LCD
DISPLAY (#10) during the snooze period.
To cancel the snooze period and the alarm, press the POWER
/SOURCE
BUTTON (#1).
RADIO OPERATION
Listening to the radio
1. Tap the POWER
/SOURCE
BUTTON (#1) to turn on the unit.
2. Tap the POWER
/SOURCE
BUTTON (#1) repeatedly to select FM or AM radio
mode.
3. The FM icon will turn on and the frequency will show on the LCD display (#10).
4. Tap the SKIP BACKWARD
BUTTON (#3) or SKIP FORWARD BUTTON
(#9) to adjust frequency.
5. Press and hold the SKIP BACKWARD
BUTTON (#3) or SKIP FORWARD
BUTTON (#9) to search for the previous or next available FM station.
6. If the reception is poor, try Manual Tuning to fine-tune the station. Tap the SKIP
BACKWARD
BUTTON (#3) or SKIP FORWARD BUTTON (#9) briefly to
manually tune through the frequency band.
7. Adjust the VOLUME CONTROL (#8) to obtain the desired volume level.
8. When you have finished listening, press and hold the POWER
/SOURCE
BUTTON (#1) to turn the radio off.
Notes:
When in radio mode, the display will automatically switch back to showing the time
after a few seconds.
When listening to the radio, you can check the frequency of the station you are
listening by tapping the SKIP BACKWARD
BUTTON (#3) or SKIP FORWARD
BUTTON (#9). The unit will automatically change back to the time after a few
seconds.
To set the radio presets
The unit allows you to store up to 10 FM stations and 10 AM stations for easy recall at
any time.
1. Press the POWER
/SOURCE
BUTTON (#1) to turn on the unit.
2. Tap POWER
/SOURCE
BUTTON (#1) repeatedly to select FM or AM radio mode.
3. Tap the SKIP BACKWARD
BUTTON (#3) or SKIP FORWARD BUTTON
(#9) to select the desired station.
4. Press and hold the SET/MEM/M+ BUTTON (#2) until “P01” shows on the LCD
DISPLAY (#10).
5. Tap the SKIP BACKWARD
BUTTON (#3) or SKIP FORWARD BUTTON
(#9) to select a preset number (P01-P10).
6. Press the SET/MEM/M+ BUTTON (#2) again to confirm the preset.
7. Repeat steps 2 through 6 to preset up to 10 stations.
To Next Page
Loading...