Studer A812 - Locate Command Keys

STUDER
AUTOLOCATOR
2.5
Locate command
keys
Key:
tr
Function:
When the
LOC
key is
pressed
the tape is
positioned
at the tape address
shown
in the
lowerfield
of the LOCATE
POSITION display.
Example
r
The tape
is to be
positioned
at
31:50 min
Input:
[*ü"-l
tr
E
rnput:
EF-"-Etrtr
rnput:
trtrtrtrtr
r
The tape
is to be
positioned
at the address stored
in memory 7:
When
the LOC
START key
is
pressed,
the
tape is spooled to the
address
at
which the
last
PI-AY or RECORD
command was entered
(but
only while
the tape
was standing
still!).
Subsequently
the machine
switches
to PI-AY or RECORD, depending
on
the
programming.
LOC START
is cancelled
by any
new
function.
When the ROLLBACK
key
is
pressed,
the tape is rewound by a
programmable
amount. When
the target address
is reached, the machine switches
to STOP,
PISY
or RECORD,
depending
on the
programming.
This function
is cancelled by
STOP, PI-AY, PI,AY+REC, LOC,
<,>,
SHUTTLE
and SHUTTLE
BAR.
To modify the
rollback time
press
STORE,
followed
by ROLLBACK, and enter
a
time
between
01 and 99. To
read out
the stored time
press
RECALL,
followed by
ROLLBACK.
Example
Set ROLLBACK
time to 20 s
EDlTl0N: 11. November 1991
Et5