Studer A812 - LOC1-4 and VARISPEED Command Keys

STUDER
AUTOLOCATOR
2.6
LOCl...4
and
VARISPEED
command
keys
Key:
Functlon:
When this key is
pressed,
the tape
recorder searches the tape
position
that is
stored in the corresponding
memory.
The
tape
position
and the
corresponding
memory
number are
shown on the LOCATE
POSITION display.
lnput:
The SHIFT
key assigns
to the LOC1.,.LOC4
keys the functions for controlling
the
variable tape
speed
(VARISPEED).
The
red
LED above
the SHIFT key indicates
the SHIFT
state. On
the LOCATE
POSITION display the tape speed
of the
machine
is
shown
in
ips
(inches
per
second).
Each of these 4 LOC
memories is loaded
by
pressing
the TRANS/REV
PIAY key
and
the
corresponding LOC
key. Possible values are those shown in the
lower
display.
Note: LOC 1 ...4 are the
same memory locations
that
can also be accessed
via the
numeric keypad.
This key activates
the variable tape speed adjustment. When the red LED above
the
key is
light,
you
can vary the tape
speed
by means of the UP
> >
DOWN
< <
keys.
ln
this mode the LOCATE POSITION
display
shows the set deviation from
the nominal speed
in
semitones
(HT)
or
percent
(PC),
depending on the display
format
selected
on the tape recorder. After the
desired speed deviation has
been set
you
can terminate this function by
pressing
the SET VS key again, the
SET
VS LED above
the key switches off.
This key activates
the
variable tape
speed
operation.
After this key has been
pressed
the red LED above the key flashes, the tape
recorder is now switched to
the speed
preselected
with the SET VS function.
The LOCATE POSITION
display
shows the current tape speed
of
the tape
recorder in ips.
Note: Also while
the VARISPEED
function is active
the SHIFT
mode can be cancelled
by
pressing
the
SHIFT key; the red
LED
above the
SHIFT key switches off, the
yellow
LED lights
up.
The red V SPEED LED continues
to flash
to indicate the
VARISPEED
mode. However, the LOCATE POSITION
display
now shows again
the
last selected LocATE PoslTloN.
The
SINGLE LOOP key can be set to INSTANT
LOOP by simple
reprogramming
in the menu
of
the tape recorder
(F259:
SINGLE
LOOP
MODE A).
When
the INSTANT LOOP key is
pressed,
the loop mode is activated
immediately.
The
loop is
executed
between
the value
in the lower display field
and the value in effect at the time the INSTANT
LOOP key was
pressed.
r
'lL'
in the right-hand section of the
display
is light
when the INSTANT LOOP
function is active.
r
The smaller of the two values is always taken
as the loop starting address.
r
The loop can be
executed
in PLAY
or RECORD
mode,
r
The loop is cancelled as soon as any new function
is entered.
Example
r;Tl
E/6
EDfT|ON: 25. November
.l991