Studer A812 - AUTO RECORD Mode

STUDER AUTOLOCATOR
2.8 AUTO RECORD mode
Key:
@
Functlon:
A
loop with
automatic
drop-in/drop-out can be
executed with the AUTO
RECORD
function.
ln addition a PREROLL and POSTROLL
can be
programmed
so that
the
editing operation can be simulated electronically
with the REHEARSE
function before it is
subsequently executed.
IN
POINT
OUT POINT
First the lN
and OUT
points
must be defined. The
lN
point
is written into
the
LOCATE
POSITION memory either by reading
out
a LOCATE
POSITION
memory,
by copying the current TAPE POSITION
with
the
t
key,
or by manually
entering
it via the keypad. For having the value
defined
as the
lN
point,
the keys
TRANS/REV
PI-AY and lN must be
pressed
consecutively.
The
same
procedure
applies analogously to the
OUT
point.
After this
entry the lN and OUT
point
can
be
checked
by
pressing
the
tN
or OUT
key.
The lN or OUT
point
is shown on the TAPE
POSITION
display
for as tong
as
the corresponding
key is
pressed.
As soon as
this key
is released,
the current
tape timer
reading reappears on
the TAPE POSITION
display.
Examples
The content
of memory
-3
is to be used as the
lN
point:
F-Aül
IREVPLAYI+[Ir']
E*"_l
lnrveLe,rl
*
lout
I
rnput:
FEcALL-]
trtrWf
The
OUT
point
should be set to
2:30 min:
,nput:
trtrtrwr
Now
the
preroll
and
postroll
must
be entered.
The
preroll
can be
programmed
as follows:
lf the
preroll
is less than
10 seconds, a
leading
zero
must be
entered, for
example:
E/8
EO|T|ON: 25. November 1991