Studer A812 - Auto Load

STUDER
AUTOLOCATOR
lnput:
2.8.1
Auto load
@rtrtr
The
postroll
is
programmed
analogously.
All
parameters
for the
AUTO
RECORD
mode are now defined.
Press
the AUTO
REC
key
to instruct
the tape
recorder
to spool to the
starting
point.
The
yellow
AUTO REC
LED
lights
up.
After
the tape has been
positioned
at
the
parking
point,
this
LED
continues
to flash
for approximately
5 seconds;
it then switches
off. During
these
five
seconds
PI:AY +
REC must be
pressed
for
starting the
machine
in
AUTO
RECORD
mode.
The
tape
recorder
switches
to
PI-AY, the REC LED flashes.
At the
lN
point
the
machine switches
to record,
the
REC LED is continuously
light. At
the OUT
point
the tape
recorder
switches
back
to
play
until the
post
roll up to
the reversal
time
is reached.
From
there
the tape
is rewound to
the
parking point.
lf desired,
this
process
can
be restarted
by
pressing
PLAY and REC.
Procedure:
F265
@
m*t
rg
E
E
1.
Yes
Functlon:
Auto load
is
used for automatically
programming
the drop-in and
drop-out
points
by
pressing
REC or
PI-AY respectively.
lf in the tape
recorder F265:
Auto
load
enable
is
set
to YES, the AUTO
LOAD
function
is automatically
assigned
to the TRANS/REV PI-AY key.
ln
the software
branch
'tape
deck,
keys only'
program
F265 to
yes.
Press the
play
key.
Press this key,
the LED flashes.
At the desired
tape
position
activate REC in order to define the drop-in address.
At the desired
tape
position
press
PI-AYto define the drop-out address.
The drop-in/drop-out
addresses
are now stored.
EO|T|ON: 25. November 1991
E/9