Studer XPC 1400-12 - Page 3

STUDER Innotec XP-COMPACT
User manual XP-COMPACT V5.1 E 2
4.8.3 Delayed mode of the Transfer System.........................................................................................................15
4.9 THE SOLAR CHARGE CONTROLLER (OPTION)....................................................................................................15
4.10 THE MULTIFUNCTIONAL CONTACT ..................................................................................................................16
4.11 THE TEMPERATURE SENSOR.............................................................................................................................16
5 The Remote Control...............................................................................................................16
5.1 REMOTE CONTROL PLUG-IN..............................................................................................................................16
5.2 POWER MONITOR..............................................................................................................................................16
5.3 BATTERY CONDITION:......................................................................................................................................17
5.4 FAULT INDICATOR............................................................................................................................................17
5.4.1 Overtemp. (10)............................................................................................................................................17
5.4.2 Overload (11)..............................................................................................................................................17
5.4.3 Battery low/high..........................................................................................................................................17
5.5 DEPORTED ALARM CONTACT AND ON/OFF CONTROL........................................................................................17
5.6 MANUAL CONTROL OF THE AUXILIARY CONTACT ............................................................................................17
6 Programming..........................................................................................................................17
6.1 STANDARD SETTING .........................................................................................................................................18
6.1.1 Battery voltage............................................................................................................................................18
6.1.2 Auxiliary contact.........................................................................................................................................18
6.2 RESET VALUE ...................................................................................................................................................18
6.3 BATTERY VOLTAGES AND ABSORPTION TIME:..................................................................................................18
6.3.1 Table of voltage and timing threshold.........................................................................................................18
6.3.2 Set the voltage and timing threshold...........................................................................................................18
6.4 PROGRAM THE AUXILIARY CONTACT ...............................................................................................................19
6.4.1 Principle......................................................................................................................................................19
6.4.2 The programming of the Auxiliary Contact is carried out in the following Steps.......................................19
6.4.3 Example ......................................................................................................................................................20
6.5 DISABLING SOME OF THE XP-COMPACT FUNCTIONS.....................................................................................20
6.5.1 Diagram of the different mode....................................................................................................................20
7 Maintenance............................................................................................................................21
8 CE Compliance.......................................................................................................................21
9 Technical Data........................................................................................................................22