Connecting speakers
Connect powered speakers to the two rear panel XLR sockets MIX OUTPUT L & R using suitable
cables. All the main outputs on digiLiVE are at standard line level and are electronically balanced.
If you’re using passive speakers with one or more separate ampliers, connect digiLiVE’s outputs
to the amplier inputs.
NOTE: It is always good practice to turn on interconnected audio devices in sequence. In this case,
turn digiLiVE on rst, then turn on your powered speakers or power amplier(s). When powering
down, turn the speakers or amplier o rst, then turn digiLiVE o. Observing this sequence will
avoid nasty loud bangs or thumps from the speakers.
Connection to passive speakers
Connection to active speakers
To Next Page
Loading...
