Studiomaster QX Series - Stereo Mode

05
The power cord must have sufficient current capacity, AC power supply voltage and frequency
must be in range of ±10% of the nominal value.
3.6 Input / output line
Common knowledge:
Try to use the shielded wire, the higher density shielding layer is the better.
Try to select balance connection for input, to reduce noise interference.
Selection of non balance connection, the shorter the better, preferably not more than 3m.
The weak signal line should avoid to parallel with the power line and the power output line,
otherwise it might produce noise.
Before changing any connection, please turn off all equipments. Otherwise, it may cause
damage to hearing and speakers.
Balanced analog input and
AES3 digital input connection
Non balanced analog input
connection
GND
SHIELD
3.61 Stereo Mode
SUN ON
PMD1 204PQ BX-A
(2).B 2220. GN
DC12 V —8.0W
SUN ON
PMD1 204PQ BX-A
(2).B 2220. GN
DC12 V —8.0W
SUN ON
PMD1 204PQ BX-A
(2).B 2220. GN
DC12 V —8.0W
SUN ON
PMD1 204PQ BX-A
(2).B 2220. GN
DC12 V —8.0W
SUN ON
PMD1 204PQ BX-A
(2).B 2220. GN
DC12 V —8.0W
SUN ON
PMD1 204PQ BX-A
(2).B 2220. GN
DC12 V —8.0W
SUN ON
PMD1 204PQ BX-A
(2).B 2220. GN
DC12 V —8.0W
CH-CCH-D CH-B CH-A
CH-D CH-A
CH-C CH-B
2+
1-
2-
1+
+
-
CH-C
+
-
8Ω
4Ω
2Ω
8Ω
4Ω
2Ω
2+
1-
2-
1+
+
-
CH-A
+
-
8Ω
4Ω
2Ω
8Ω
4Ω
2Ω
2+
1-
2-
1+
+
-
CH-D
8Ω
4Ω
2Ω
2+
1-
2-
1+
+
-
CH-B
8Ω
4Ω
2Ω
CH-B
CH-D
CH-B
CH-D
CH-A
CH-C