Stulz CyberWall CAH - INSTALLATION; Receiving the Equipment; Storage

To Next Page

To Previous Page

CYBERWALL™ INSTALLATION, OPERATION AND MAINTENANCE MANUAL

INSTALLATION

Receiving the Equipment

Your CyberWall™ unit has been inspected and tested prior to shipment. To ensure it is received in factory

condition, immediately inspect the unit for damage incurred during shipment. If any is found, report it to

the carrier immediately. Any obvious shipping damage must be noted on the freight carrier’s delivery forms

before signing for the equipment. Freight claims must be ﬁled through the freight carrier.

Generally, all equipment ships FOB Factory. In the event of damage during shipment, STULZ can assist in the

claim ﬁling process with the freight company. Refer to section 5.0 Product Support for instructions.

Carefully remove the shipping cover. Remove any loose parts and check the equipment against the packing

list to verify the shipment is complete. Report all discrepancies to the appropriate authority. Inspect the

interior of the unit for any signs of transit-incurred damage. If there is any damage, notify STULZ Product

Support. Do not attempt any repairs.

A data package has been sent with your unit. It contains this manual, system drawings, applicable Safety Data

Sheets, warranty registration form and other component manuals and applicable instructions based on the

conﬁguration and options included with your unit. The data package has been placed in your unit inside a

clear plastic bag. These documents should be retained with the unit for future reference.

NOTE

Items that have been shipped loose, are shipped inside the air conditioner unless speciﬁed otherwise by

the customer. Unpack and store these items in a safe place unless you are using them immediately.

Storage

Indoor Storage

Indoor air handlers and ﬁeld-installed accessories must be protected from the elements. Outdoor storage is

not recommended for units that will be installed indoors. A controlled indoor environment is recommended

for proper storage. The indoor storage area conditions should be maintained between 41°F to 86°F (5°C

to 30°C) and a non-condensing environment, unless speciﬁed otherwise. If the unit is to be stored after

unpacking from the original factory packaging, then it should be repackaged using equivalent means and

material. Ensure the follow to prevent damage:

• Do not remove the factory cover. Ensure cover is complete and was not penetrated during shipping. Repair

cover as needed. The shrink-wrapped packaging used has a corrosion inhibitor layer integrated.

• If the factory shrink-wrap cover has been removed, cover the unit securely with a canvas tarp. Plastic tarps

can cause condensation to form in and on the equipment, which could result in corrosion damage or wet

storage stains.

• Place the unit on a dry surface or raised off the ground to assure adequate air circulation beneath the unit

and to assure no portion of the unit will contact standing water at any time.

• Do not stack units.