What to do if my Sturdy SA-300MA displays 'E107: USB is full' error?
If your Sturdy Laboratory Equipment shows 'E107: USB is full', it means the storage medium has reached its maximum limit. Immediately back up the storage medium onto a secure zone, then follow the procedure '7.5.2.4 Download' to download the last record.
Why does my Sturdy SA-300MA Laboratory Equipment have no display?
If your Sturdy Laboratory Equipment displays no image, make sure the main switch is turned on, the power cable is properly plugged in, and there are no bad connections. If the problem persists, contact your local distributor for service.
What to do if Sturdy SA-300MA Laboratory Equipment displays 'E105: No USB memory'?
If your Sturdy Laboratory Equipment shows 'E105: No USB memory', insert a USB flash drive. If the issue continues, detach and re-insert the memory card again.
Specifies location requirements for optimal performance and safety.
Step-by-step guide for the physical setup of the sterilizer.
Defines the purpose and applications of the sterilizer.
Details the physical components and internal configuration of the sterilizer.
Essential steps before initiating any sterilization cycle.
Procedure for executing standard sterilization cycles.
Specific program for re-drying items to ensure dryness.
Procedure for sterilizing liquid substances.
Specialized program for prion sterilization protocols.
Procedure for conducting the Bowie-Dick test for air removal efficacy.
Procedure for testing the functionality of the sterilizer's pump.
Defines the purpose and functional scope of the data recording system.
Specifies the types, formats, and content of data recorded during sterilization cycles.
Instructions for performing biological validation tests for sterilization.
Procedure for the Bowie-Dick test to verify air removal.
Procedure for the Helix test to verify steam penetration.
Daily cleaning and checks to maintain the sterilizer.
Weekly maintenance tasks including cleaning trays and replacing water.
Monthly cleaning of water level sensor and safety valve check.
Annual service recommendations, including gasket inspection and replacement.
Provides a list of common problems, their potential causes, and recommended solutions.
Explains the meaning and implications of various error codes displayed by the autoclave.
General| Brand | Sturdy |
|---|---|
| Model | SA-300MA |
| Category | Laboratory Equipment |
| Language | English |
To Next Page