EasyManua.ls Logo

Style selections SSD200TA2 - User Manual

Style selections SSD200TA2
33 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
WARNING: IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED
EXACTLY, A FIRE MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL
INJURY, OR LOSS OF LIFE.
– Do not store or use gasoline or other ammable vapors and liquids in vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas
supplier’s instructions.
• If you cannot reach your gas supplier, call the re department.
– Installation and service must be performed by a qualied installer, service agency or the
gas supplier.
This appliance may be installed in an aftermarket, permanently located manufactured
(mobile) home, where not prohibited by local codes. This appliance is for use with the
type of gas indicated on the rating plate only. This appliance is not convertible for use
with other gases.
This is an unvented gas-red heater. It uses air (oxygen) from the room in which it is
installed. Provisions for adequate combustion and ventilation air must be provided.
Refer to Air For Combustion and Ventilation section on page 8 of this manual.
INSTALLER : DO NOT DISCARD THIS MANUAL - LEAVE FOR HOMEOWNER'S
FUTURE REFERENCE.
WARNING: This appliance is
equipped for (Natural and
Propane) gas. Field conversion is
not permitted other than between
natural or propane gases.
LS-ED200T2651B-0902
Questions, problems, missing parts? Before returning to your retailer, call our
customer service department at 1-866-573-0674, 8:00 a.m - 4:30 p.m., EST,
Monday - Friday or e-mail customerservice@usaprocom.com.
ITEM #0293808
VENT-FREE GAS FIREPLACE SYSTEM
MODEL #SSD200TA2
Español p. 34
CAUTION - FOR YOUR SAFETY

Table of Contents

Questions and Answers

  • P
    preillyAug 18, 2025
    What to do if my Style selections SSD200TA2 Indoor Fireplace has a spark but no pilot flame?
    • A
      Anna HayesAug 18, 2025
      If the Style selections Indoor Fireplace shows a spark but no pilot flame, ensure the gas supply is on and the equipment shutoff valve is open. Fully press the control knob while pressing the ignitor button. If it's a new installation or there has been a recent gas interruption, continue holding down the control knob for 30 seconds to remove air, repeating the igniting operation until the air is cleared. Also, the ODS/pilot might be clogged and needs cleaning, or the inlet gas pressure may be incorrect, or the gas supply may be depleted.
  • B
    Bradley MoralesAug 20, 2025
    Why does the pilot light go out on my Style selections SSD200TA2 when I release the control knob?
    • J
      jose03Aug 20, 2025
      If the ODS/pilot light of your Style selections Indoor Fireplace goes out when the control knob is released, make sure the control knob is fully pressed in and held for 30 seconds after the pilot lights. Also, ensure the equipment shutoff valve is fully open. Check the thermocouple connection to ensure it is snug, tightening it an additional ¼ turn if necessary. The thermocouple may be damaged and need replacement, or the control valve may be damaged.
  • T
    Tanya MosleyAug 23, 2025
    Why does my Style selections Indoor Fireplace shut off while in use?
    • J
      John HodgeAug 23, 2025
      If your Style selections Indoor Fireplace heater shuts off during use while the ODS is operating, it could be due to insufficient fresh air. Try opening a window or door for ventilation. It may also be due to low line pressure. The ODS/pilot may also be partially clogged.
  • J
    Jacob DominguezAug 26, 2025
    How to fix no spark at the pilot light of my Style selections SSD200TA2 Indoor Fireplace?
    • S
      stephenlopezAug 26, 2025
      If there is no spark at the ODS/pilot when the ignitor button is pressed on your Style selections Indoor Fireplace, the ignitor electrode may be positioned wrong or broken and needs replacement. The ignitor cable might be pinched, wet, or damaged and needs replacement or freeing. The piezo ignitor could be bad and needs replacement, or the battery may be low and needs replacement.
  • M
    Melanie JonesAug 28, 2025
    What to do if burner won't light on my Style selections SSD200TA2 Indoor Fireplace after the pilot is lit?
    • R
      ryancoxAug 28, 2025
      If the burner(s) on your Style selections Indoor Fireplace do not light after the ODS/pilot is lit, the burner orifice may be clogged and needs cleaning, or the burner orifice diameter may be too small and needs replacement, or the inlet gas pressure may be too low.
  • T
    Travis SchmidtAug 30, 2025
    Why do I smell gas when my Style selections SSD200TA2 Indoor Fireplace is off?
    • J
      Jamie ValdezAug 30, 2025
      If you smell gas from your Style selections Indoor Fireplace even when the control knob is in the OFF position, there may be a gas leak, or the control valve may be defective.
  • L
    lauren61Sep 2, 2025
    Why is the flame yellow on my Style selections SSD200TA2 Indoor Fireplace?
    • E
      erichaleSep 2, 2025
      A high yellow flame during burner combustion in your Style selections Indoor Fireplace indicates that there is not enough air, the gas regulator is defective and needs replacement, or the inlet gas pressure is too low.
  • E
    ericahuntSep 4, 2025
    Why is there a delay when the burner ignites on my Style selections SSD200TA2?
    • R
      rosariomonicaSep 4, 2025
      Delayed ignition of the burner(s) in your Style selections Indoor Fireplace could be due to low manifold pressure, or a clogged burner orifice.
  • J
    Judy WilliamsSep 7, 2025
    What causes burner backfiring in my Style selections SSD200TA2 Indoor Fireplace?
    • S
      Steven BoyerSep 7, 2025
      Burner backfiring during combustion in your Style selections Indoor Fireplace can occur if the burner orifice is clogged or damaged, the burner is damaged, or the gas regulator is damaged and needs replacement.
  • G
    Gloria PerkinsSep 9, 2025
    Why does my Style selections Indoor Fireplace smell?
    • E
      Emily MorrisSep 9, 2025
      If your Style selections Indoor Fireplace produces unwanted odors, it might be burning vapors from paint, hair spray, glues, etc. Ventilate the room and stop using odor-causing products while the heater is running. There could also be a gas leak. Also, check the fuel supply.

Style selections SSD200TA2 Specifications

General IconGeneral
BrandStyle selections
ModelSSD200TA2
CategoryIndoor Fireplace
LanguageEnglish

Related product manuals