EasyManua.ls Logo

Style selections SSFBD28T - User Manual

Style selections SSFBD28T
31 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
WARNING: IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED
EXACTLY, A FIRE MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL
INJURY, OR LOSS OF LIFE.
– Do not store or use gasoline or other ammable vapors and liquids in vicinity of
this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas
supplier’s instructions.
• If you cannot reach your gas supplier, call the re department.
– Installation and service must be performed by a qualied installer, service agency
or the gas supplier.
This appliance may be installed in an aftermarket, permanently located manufactured
(mobile) home, where not prohibited by local codes. This appliance is for use with the
type of gas indicated on the rating plate only. This appliance is not convertible for use
with other gases.
This is an unvented gas-red heater. It uses air (oxygen) from the room in which it is
installed. Provisions for adequate combustion and ventilation air must be provided.
Refer to Air For Combustion and Ventilation section on page 8 of this manual.
INSTALLER : DO NOT DISCARD THIS MANUAL - LEAVE FOR HOMEOWNER'S
FUTURE REFERENCE.
Questions, problems, missing parts? Before returning to your retailer, contact
our customer service department at 1-866-573-0674, 8:00 a.m - 4:30 p.m.,
EST, Monday - Friday or e-mail customerservice@usaprocom.com.
WARNING: This appliance
is equipped for (Natural and
Propane) gas. Field conversion is
not permitted other than between
natural or propane gases.
LS-FBD28D654-1002
ITEM #0030334
VENT-FREE GAS FIREPLACE INSERT
MODEL #SSFBD28T
Español p. 32
CAUTION - FOR YOUR SAFETY

Table of Contents

Questions and Answers

  • R
    rgordonAug 18, 2025
    What to do if there is spark but no pilot flame on my Style selections SSFBD28T Indoor Fireplace?
    • V
      Victoria HughesAug 18, 2025
      If there's a spark but no pilot flame on your Style selections Indoor Fireplace, first, make sure the gas supply is on and the equipment shutoff valve is open. Ensure the control knob is fully pressed in while pressing the ignitor button. If it's a new installation or there was a recent gas interruption, hold down the control knob for 30 seconds to remove air from the gas lines, repeating the igniting operation. Also, the ODS/pilot might be clogged, so clean it or replace the ODS/pilot assembly. Check the inlet gas pressure, and if it's incorrect or the inlet regulator is damaged, replace the regulator. Finally, consider whether the gas supply is depleted, and if so, contact your local propane/LP Gas Company.
  • M
    maldonadopamelaAug 20, 2025
    Why does the pilot light go out when I release the control knob on my Style selections Indoor Fireplace?
    • J
      Jeffrey LawsonAug 20, 2025
      If the ODS/pilot light of your Style selections Indoor Fireplace goes out when you release the control knob, ensure the control knob is fully pressed in and held for at least 30 seconds after the ODS/pilot lights. Also, make sure the equipment shutoff valve is fully open. Check the thermocouple connection and hand tighten it until snug, then tighten a ¼ turn more. If the issue persists, the thermocouple may be damaged and require replacement.
  • E
    Emily RobinsonAug 23, 2025
    Why does my Style selections Indoor Fireplace keep shutting off?
    • G
      gdawsonAug 23, 2025
      If your Style selections Indoor Fireplace heater shuts off during use, with the ODS operating, it could be due to several reasons. First, ensure enough fresh air is available by opening a window or door for ventilation. Additionally, low line pressure could be the cause, so contact your local gas supplier. Lastly, the ODS/pilot might be partially clogged, so consider cleaning it.
  • C
    Cynthia WrightAug 26, 2025
    How to fix no spark at pilot light on Style selections SSFBD28T Indoor Fireplace?
    • A
      andrea99Aug 26, 2025
      If there is no spark at the ODS/pilot when you press the ignitor button on your Style selections Indoor Fireplace, it could be due to several reasons: * The ignitor electrode might be positioned wrong or broken, in which case you should replace it. * The ignitor electrode might not be connected to the ignitor cable, or the ignitor cable is damaged, so replace the ignitor cable. * The ignitor cable could be pinched or wet, so free it from any metal or tubing and keep it dry. * The piezo ignitor might be bad, so replace it. * The battery might be low, so replace it.
  • H
    Heather SandersAug 27, 2025
    What to do if burner won't light after pilot on Style selections SSFBD28T Indoor Fireplace?
    • J
      jacob01Aug 27, 2025
      If the burner(s) on your Style selections Indoor Fireplace do not light after the ODS/pilot is lit, it could be because the burner orifice is clogged, in which case you should clean the Burner orifice. Alternatively, the burner orifice diameter might be too small, requiring you to replace the burner orifice.
  • A
    Andrew PriceAug 29, 2025
    Why does my Style selections SSFBD28T smell?
    • A
      Adam BurnsAug 30, 2025
      If your Style selections Indoor Fireplace produces unwanted odors, it might be burning vapors from paint, hair spray, glues, etc., so ventilate the room and stop using odor-causing products while the heater is running. It could also be due to a gas leak, so locate and correct all leaks. Lastly, check if the fuel supply is low and refill the supply tank if needed (Propane /LP models).
  • C
    Curtis JohnsonSep 1, 2025
    Why is there a high yellow flame in my Style selections Indoor Fireplace?
    • R
      rosevanceSep 1, 2025
      If you notice a high yellow flame during burner combustion in your Style selections Indoor Fireplace, it could be due to not enough air. Check the burner for dirt and debris and clean it if necessary. Another possible cause is a defective gas regulator, which would need to be replaced.
  • M
    Michael WilcoxSep 3, 2025
    Why do I smell gas when my Style selections Indoor Fireplace is on?
    • B
      Brian WebbSep 3, 2025
      If you notice a gas odor during combustion in your Style selections Indoor Fireplace, there might be foreign matter between the control valve and burner, so take apart the gas tubing and remove any foreign matter. Alternatively, there could be a gas leak, so locate and correct all leaks.
  • B
    Bobby Thomas Jr.Sep 6, 2025
    Why do I smell gas when my Style selections SSFBD28T Indoor Fireplace is off?
    • J
      Jeanette ShermanSep 6, 2025
      If you smell gas even when the control knob of your Style selections Indoor Fireplace is in the OFF position, it is likely due to a gas leak, so locate and correct all leaks. Alternatively, the control valve may be defective.
  • A
    anthonycynthiaSep 8, 2025
    Why is my Style selections SSFBD28T whistling?
    • J
      jessica86Sep 8, 2025
      If your Style selections Indoor Fireplace produces a whistling noise when the burner is lit, try turning the control knob to the low (1) position and let it warm up for a minute. The noise could also be due to air in the gas line, so operate the burner until the air is removed from the line. Additionally, check if the air passageways on the heater are blocked. It might also be a dirty or partially clogged burner orifice, which requires cleaning.

Summary

SAFETY INFORMATION

CARBON MONOXIDE POISONING

Details the risks and symptoms of carbon monoxide poisoning.

AIR FOR COMBUSTION AND VENTILATION

PRODUCING ADEQUATE VENTILATION

Ensures sufficient indoor air volume for combustion and ventilation.

Confined and Unconfined Space

Defines confined and unconfined spaces based on volume calculations.

Unusually Tight Construction

Details criteria for defining unusually tight building construction.

DETERMINING FRESH-AIR FLOW FOR HEATER LOCATION

Ventilation Air From Inside Building

Ventilation Air From Outdoors

INSTALLATION

CLEARANCES TO COMBUSTIBLES

Specifies minimum distances from combustible materials.

Minimum Wall and Ceiling Clearances

CONNECTING TO GAS SUPPLY

Gas Supply Conversion

CHECKING GAS CONNECTIONS

Pressure Testing Gas Supply Piping System

Pressure Testing Heater Gas Connections

OPERATION

FOR YOUR SAFETY READ BEFORE LIGHTING

Essential safety warnings and precautions before lighting the appliance.

WHAT TO DO IF YOU SMELL GAS

Steps to take immediately if a gas leak is detected.

LIGHTING INSTRUCTIONS

TO TURN OFF GAS TO APPLIANCE

MANUAL LIGHTING PROCEDURE

INSPECTING BURNERS

CARE AND MAINTENANCE

CLEANING BURNER INJECTOR HOLDER AND PILOT AIR INLET HOLE

CLEANING ODS;PILOT

TROUBLESHOOTING

When ignitor button is pressed in, there is no spark at ODS;pilot.

When ignitor button is pressed in, there is a spark at a ODS;pilot but no pilot flame present.

ODS;pilot lights but flame goes out when control knob is released.

Burner(s) does not light after ODS;pilot is lit.

Delayed ignition of burner(s).

Burner backfiring during combustion.

High yellow flame during burner combustion.

Gas odor during combustion.

Slight smoke or odor during initial operation.

White powder residue forming within burner box or on adjacent walls or furniture.

Heater produces unwanted odors.

Heater shuts off in use (ODS operates).

Gas odor exists even when control knob is in OFF position.

REPLACEMENT PARTS

2-YEAR LIMITED WARRANTY

Style selections SSFBD28T Specifications

General IconGeneral
BrandStyle selections
ModelSSFBD28T
CategoryIndoor Fireplace
LanguageEnglish

Related product manuals