ARM-GZB208-E1-1
12
Skin rejuvenation：5-7 days each time，can use this device for a long
period;
8.2 About Operation
1) Adjust energy level
a) Adjust energy level from low to high：Don’t adjust much for one time；
b)Test before operation：watch whether the shot is normal before treatment；
c) Deep color skin shall use low energy level；
2) Note during operation
1） Long hair can absorbs more light energy and this may hurt skin. So
before hair removal, cut off the longer hair（leave hair 2~3mm long）;
2） Forehead, upper lip, chin —Skin is very thin, so use low energy level;
Customer may feel a little pain during hair removal；
3） Make the tip fully touch skin to ensure skin absorb enough light hand heat；
4） During HR operation mode, delay between two treatments shall be 30s
8.3 Operation Procedure
1） Clean skin；
2） Start equipment and adjust relative energy level；
3） We advise users to wear goggles；
4） HR mode：first make test on skin with no hair: if skin turns a little red and
a little heat, it means the energy level you set is available, then you can
remove hair；
5） SR mode：first make test on skin under jawbone: if kin turns a little red
and a little heat, it means the energy level you set is available, then you
can treat with face from the bottom up；
6） Make treatment on entire parts; During treatment watch skin’s reflection
for adjusting in time;
7） Clean treated parts after treatment；
8） Treated skin needs moisturizing and avoid sunshine
Suggestion：
A) Before treatment, smear some beauty products on skin with
moisturizing, whitening or renovating functions according to skin’s
situation;
B) After treatment, use home beauty products on skin with moisturizing,
whitening or renovating functions to make skin smooth and shiny
To Next Page
Loading...