EN-18
1. Computer unit still in the setting phase. You need to set the
computer and then move on to the operating phase.
2. The distance between the computer unit and sensor, between
sensor and magnet exceeds effective transmission range. Or, the side
marked with ‘sensor’ is not in the right angle. You need to relocate the
parts to the required position and angle.
3. Wrong wheel circumference setting. Enter into the setting menu.
Reset wheel circumference.
4. Low power level. Battery installed in the sensor need to be replaced
5. High voltage may cause this product to malfunction. Please move it
away from any source of high voltage.
Product Specifications
Battery(Computer&Sensor)
Sensor Signal transmission
Working Temperature
Dimensions
Weight
Model
2.4GHz
0°C-50°C (32°F-122°F)
6.3*4*2cm(2.5*1.6*0.8 inch)
30g
3000
Approx. 1 year (when
using this device 1
hour/day)
Battery Life
Battery Material Li-MnO2
Battery Model No.
Voltage
Battery Capacity
Power
CR2032
3.0V
210mAh
0.63W
To Next Page
Loading...