EN-6
How to use the LED flashlight?
1. Double-click the master button to turn on the flashlight.
2. Single-click the button to change the flashlight mode in sequence:
Strong →Strobe →SOS →Off.
How to start a 12V/24V vehicle?
1. Check the remaining power. Make sure that the residual capacity
of the jump starter is more than 75% when you are going to start a
24V vehicle, or more than 50% when you are going to start a 12V
vehicle.
2. Connect the red clamp to the positive polarity(+) of the car
battery and black clamp to the negative one(-). If 12V or 24V
indicator light is solidly on, you can move on to step 3. If 12V
and/or 24V light(s) flash(es), follow the guidance in the ‘Manual Force
Start’ section.
3. Start the engine.
4. Remove the clamps from the car battery immediately after use.
3
4
RE D: "+ "
BLACK:" -"
1 2
To Next Page
Loading...
