EN-7
Manual Force Start
NOTE: There is no short circuit protection under manual force start
mode. Please make sure that the battery clamps are connected
correctly.
1. Disconnect the clamps from the battery of your vehicle.
2. Confirm the voltage of your vehicle.
1) If the voltage of your vehicle is 12V, you need to hold the FORCED
START 12V button for 5 seconds. The 12V indicator light will be on.
The jump starter would now supply 12V output.
2) If the voltage of your vehicle is 24V, you need to hold the FORCED
START 24V button for 5 seconds. The 24V indicator light will be on.
The jump starter would now supply 24V output.
Move on to the next step within 45 seconds. Otherwise, the jump
starter will cut off the output automatically.
3. Connect the red clamp to the positive polarity(+) of the car battery
and the black clamp to the negative one(-).
4. Start the engine.
5. Remove the clamps from the battery of your vehicle. The 12V and
24V indicator lights will keep flashing until the clamps are removed.
To Next Page
Loading...
Need help?
General
