Suaoki PS5B - Technical Specifications

8
1.Before starting,make sure the red and black clips are clamped tightly to the battery poles of your
car,keep the two clips with enough safety distance,to prevent the two from falling off or collision
because of the engine vibration after car starting.
2.It is strictly prohibited to connect the red and black clip directly,otherwise it may cause accidents.
3.Please keep away from the engine when starting the car to avoid any physical injury that may
caused by car engine running.
4.Please remove the product from battery within 30 seconds after engine started,otherwise it might
cause damage to the portable power supply or even cause accident.
5.Please check the battery capacity before every re-start.Make sure the power is over 60%(four
battery segments on).
6.People who are not familiar with this product(especially children) is strictly prohibited to use this
function.
Notice
1. Make sure the gas engine displacement of the vehicle is not more than 4L.
2. Make sure the power is over 60%(four battery segments on).
3. Make sure the clamps of the battery clamps is not broken.
Steps:
1. Plug the intelligent battery clamps into the jumping port of your portable power supply.If green
and red lights are on simultaneously,the connection is conrmed to be correct.
2. Connect the positive and the negative polarities of the battery clamps to the positive and the
negative polarities of battery(Red to +,black to -).If the green light is on ,then you can start you car.
If green and red lights are on simultaneously,you can try to open the head lamp of vehicle or air-
conditioner(the clamps need to be activated).
3. Turn the auto key to start the auto
4. Disconnect the clamps with battery and the jumping port of your portable power supply.
The rst step and the second step can be exchanged.Only when the indicator light of the clamps
turns to green,then you can start you car.
5. Technical Specications
Battery Capacity 400Wh
Input
AC Adapter 14V~40V(Standard: 72W/29.4V)
Car Charger 12/24V
Solar Panel 10A(Max)/14V
～
40V