· 3 ·
● Charging the jump starter
Both the power adapter and the car charger can charge the jump starter.
Charging with adapter
First step: Insert the adapter into a socket.
Second step: Insert the other end of the adapter into the input port of the jump starter.
Charging with car charger
1. Plug the car charger into the socket of cigarette lighter on your 12V vehicle.
2. Insert the other end into the input port of the jump starter.
※ Note:
1. You'd better charge it at least once a month in order to extend battery life.
2. Don’t charge it immediately after using it to start a car or while it is still hot.
3. It takes around 4 hours to be fully charged (with original adapter). Prolonged charging
time is a practice best to be avoided as it may raise safety concerns and shorten
battery life.
● Jump starting a car
Remember to check the remaining power capacity of the jump starter. When less than
two indicator lights are on, do not use it to jump start a car.
1. Connect the red clamp to the positive
terminal(+) of the vehicle’s battery and
the black clamp to negative one(-).
2. Connect the battery clamp with the jump
starter.
3. Start the car. If the auto cannot be started,
you need to disconnect the battery clamp
from the jump starter and the vehicle. Wait
for at least 30 seconds, then repeat the
steps above.
4. Remove the battery clamp from the jump
starter and then remove the red and black
clamps from car battery immediately.
EN
To Next Page
Loading...
Need help?
General
