1. During this process, if the red light of the clamp is on and built-in buzzer is beeping,
you need to disconnect the battery clamp from the jump starter, wait for at least 30
seconds and then go back to the first step.
2. Step 1 comes before step 2. For safety concern, please do not reverse the order.
3. DO NOT use the jump starter to start the car in high frequency, the time interval
between two starting attempts must be longer than 30s.
4. Disconnect the battery clamp from the jump starter and the vehicle immediately after
every starting attempt.
5. The jump starter cannot be used as a charger for the car battery.
6. It is recommended to use the smart battery clamp that comes with this jump starter.
Our smart battery clamps have short-circuit protection and reverse-polarity protection.
Meanwhile, the indicator light on it can prompt you if you have connected the clamp
correctly or not. Other clamps may not have the same function and thus cannot be
used in the same way.
7. Remember to check the remaining power capacity of the jump starter. DO NOT use the
jump starter to start a car when the remaining capacity is less than 30% or when it is still hot.
· 3 ·
Charging with car charger
1. Plug the car charger into the socket of cigarette lighter on your 12V vehicle.
2. Insert the other end into the input port of the jump starter.
※ Note:
1. You'd better charge it at least once a month in order to extend battery life.
2. Don’t charge it immediately after using it to start a car or while it is still hot.
3. It takes around 6.5 hours to be fully charged (with original adapter). Prolonged charging
time is a practice best to be avoided as it may raise safety concerns and shorten
battery life.
● Jump starting a car
Attention
First step: Second step:
EN
To Next Page
Loading...
