· 5 ·
● Step 3-a
Start the auto. If the auto is started successfully, the indicator light would turn
red. Then, move on to Step 4.
If the auto cannot be started, you need to disconnect the battery clamp from the jump
starter and the vehicle. Wait for at least 30 seconds, then repeat the steps above.
● Step 4
Immediately remove the battery clamp from the jump starter and then remove
the red and black clamps from car battery.
● Step 3-b
Force start the auto. After that, move on to Step 4.
※ Note:
Short circuit protection will be disabled when using the force start function. Make
sure that the black clamp and the red clamp are connected correctly before using this mode.
Q: When would I use force start function?
You would need to use this force start function when the voltage level of car battery is lower
than 1V due to severe damage or when you want to test the jump starter’s functionality with
no battery in the car.
Q: How to use force start function?
Hold the force start button on the battery clamps (see the following picture) for 3 seconds.
The indicator light would turn green. Within 15 seconds, you need to start your car. The
indicator light would turn red if started correctly.
Force start button
EN
To Next Page
Loading...
