Sub-Zero 542 - Preparation for Installation

PRI -INSTALLATION
INSTRUCTIONS
I I I IIIII IIIIIII I I I IIIII IIIIII I I HIII
PREPARATION FOR
INSTALLATION
Step 1
Prepare the finished rough
opening to accept the
installation of the Sub-Zero.
NOTE: Carefully read
the "Pre-lnstallation
Specifications" chart
below.
90 °
DOOR
Figure 2
PRE-INSTALLATION SPECIFICATIONS
LOCATE ELECTRICAL
OUTLET WITHIN TOP
St-_DED _ NE,,
LOCATE_ SUPPLY
WITHIN BOTIOM
_DAREA =W"
SHUT OFF V4LV£
A '_
MODELS 501F AND 501R
/" A ._
Figure I
MODELS 511, 532, 542, 550, 561 AND 590
MODEL
DOOR PANEL
DIMENSIONS
(WIDTH x HEIGHT)
FINISHED
ROUGHOPENING
DIMENSIONS
A* B
351/2- 723/4.
351/2. 723/4"
29V2" 833/4"
47V2" 833/4"
411/2" 833/4"
35V2" 833/4"
" 35V2" 833/4",
47V2" 833/4"
501F 34Ve" x 58Wls"
501R 341/e"x 581s/is"
511 28V8" x 48V1s"
28V8" x 183/8"
532 17_s/le"x 671V_s"
27_/_'x 67_V_s"
542 155/e"x 67W1s"
24"x 67_V_s"
550
561
590
34Ve" x 481/16"
34Vs" x 183/8"
145/e"x 67Wte"
19Ve'x 67W_s"
15Ve" x 67"As"
20shs" x 6711/16"
Grille Panel: 9_hs'x 46ahs"
MINIMUM DOOR
CLEARANCE
REQUIRED AT 90"
C
36V_"
36V1s"
301A_.
291/4.
25_/1_.
36V_"
203/4.
I 29'/4"
(Handle Trim Panels not to exceed .050" thickness)
Refrigerator, Upper Trim Panel: 6_/e"x 257/32"
Refrigerator, Lower Trim Panel: 67/8"x 317/32"
Freezer Trim Panel: 2shs"x 67_1/_2"
MINIMUM HEIGHT
REQUIRED
(withlevelers in)
727/_s"
727/16.
827/8-
82z/e•
827/e.
827/e.
82_/e.
82z/e-
*When units are Installed side by side, a separating filler strip is recommended. The filler strip width should
be added to the finished rough opening dimension. A filler strip must also be used when units are ins* d
hinge to hinge.
"*Routing or Recessing may be required on raised panels for finger clearance under handle. Refer to Figures
28 and 29 -- "Handle Recess Specs and Recommendations for Raised Panels."