To operate the water dispenser,
press the water dispenser key
pad continuously until your
container is filled. The key is
located on the refrigerator door
glasswell. The first time you use
the water dispenser, purge the
water system and storage tank
for three minutes. This will clear
out any air in the system, along
with foreign material in the new
plumbing connection.
Initially, for water to dispenser
properly, the water dispense key
pad must be depressed and held
until water flows from the
dispenser. You may have to hold
the key for 60 seconds for the
water to fill the internal reservoir
tank.
Ice Dispenser
Operating Tips
• If there’s no ice, check to make
sure the ice maker system is
turned on and that the ICE
indicator light is on.
• Make sure there’s a supply of
ice in the ice bucket. See Ice
Bucket Removal, page 17.
• Make sure the ice bucket is all
the way in and engaging the
auger motor at the back of the
bucket. If the ice bucket is not
all the way back, push on the
bucket and ice dispenser switch
at the same time.
• Make sure the freezer utility
rack is properly installed, to
make sure the ice bucket is
properly positioned. See
Freezer Utility Rack, page 17.
• Press the ice dispenser key. If
you do not hear auger motor
noise, wait five minutes, then
try again. If you do not hear
auger noise after the second
try, call your local Factory
Authorized Service Center.
• If the ice dispenser is not used
for a long period, the ice may
fuse together. To avoid this,
empty the ice bucket as
needed.
18
sing your sub-Zero
U
sing your sub-
Zero
To Next Page
Loading...
Need help?
General
