SUB-ZEROBU_LToINUSE& CARE
ELECTRONICCONTROL SYSTEM
The Electronic Control System of your
Sub-Zero BuiJtdn unit monitors and accurately
displays temperatures within one degree of
your preset temperature, it also monitors oper-
ation of the unit and Jets you know if there's a
problem, You'll find the Control Center located
in the refrigerator section of all models, except
Model 601F where it is in the freezer section,
Refer to the iJhJstrations below,
TEMPERA_I URE CON_I ROL
Your new refrigerator/freezer was thoroughly
inspected and tested before it was shipped
from the Sub-Zero factory. Temperatures are
preset at 38°F (3°C) in the refrigerator section
and 0°F (-18°C) in the freezer section.
For combination units, there are two sets of
WARMER and COLDER key pads on the
Control Center, one for the refrigerator section
and the other for the freezer section. Models
601R, 601RG and 601F have only one set of
WARMER and COLDER key pads,
To adjust the temperature in either section,
depress the WARMER or COLDER key pads
on the Control Centen
The temperature ranges are -5°F (-21°C) to +5°F
(-15°C) in the freezer section, and 34°F (1%) to
45°F (7°C) in the refrigerator section, It is
normal for temperatures to fluctuate slightly,
depending on external influences such as an
open door, the degree of humidity and room
temperature.
IMPORTANT NOTE: Always allow 24 hours
for the refrigerator to reach the temperature
you set,
Freezer / Bell
Control / On/Off
Refrigerator Unit
Control On/Off
i Freezer
Control
i On/Off
12
Ebctlro_ic Cor_t_o_ Cer_e_
IEbct_'or_ic Cor_tlre_ Ce_te_' -
Mode_s _,_85 a_d 195