TROUBLESHOOTINGGUIDE
FREQUENTLY ASKED QUESTIONS
ICE PRODUC°I ION
IMPORTANT NOTE: Make sure that the power
is on for your ice maker, iCE wiii be visible in
the Control Center display panel.
IMPORTANT NOTE: Dispose of the first bucket
of ice produced by your new unit to ensure
that pipe residue or other particles associated
with new water lines are not consumed.
Q: My ice maker isn't producing very much ice.
A: On average, you can expect a cycle of ice
(eight cubes per cycle) every two hours.
Q: My ice is freezing together and clumping.
A: if ice is not used regularly it tends to fuse
together. You may need to discard the ice
and allow ice to be replenished.
Q: My ice tastes funny and is discolored.
A: Sub-Zero Built-In units do not have an
integrated water filtration system. Contact a
local plumber to discuss water filtration
options,
NOISE
Q: Why do I hear my unit running constantly?
A: it is normal to hear the operation of fans
and motors. Sounds will be accentuated
based on the placement of the unit and
overall room design.
TEHPERAT URE
IMPORTANT NOTE: Unless the unit is being
serviced, make sure the power for your unit is
on. If the unit is not on, OFF will be visible in
the Control Center display panel.
Q: How do I adjust the temperatures?
A: To adjust temperatures, refer to Tempera-
ture Control, page 12_
Q:
A:
What are the suggested temperature
settings?
The recommended settings are 38°F (3°C)
for the refrigerator section and 0°F
(-18°C) for the freezer section.
Q:
A:
Condensation is forming on the inside and
outside of my unit.
In climates with higher humidity, condensa-
tion will form and is considered normal
Leaving the door open for a long period of
time may also contribute to condensation
forming on the inside your unit.
Q: My unit isn't cooling properly,
A: Clean the condenser area as outlined on
page 22.
DOOR OPERA_I ION
Q:
A:
Why is my door hard to open'?
Your unit was designed for an airtight seal
A vacuum seal can form after the door is
closed. Wait several seconds for pressure to
equalize before reopening the door.
Q:
A:
The door on my unit is opening too fast and
hitting the wall or surrounding cabinets.
The unit may not be leveled properly or a
door stop may be required. Contact your
Sub-Zero dealer for details on the door
stop kit.
37
To Next Page
Loading...
Need help?
General
